How to apply Prima pressed glitters
Prima Pressed Glitters have a built-in adhesive, they may be different to any product you have used before. They have a gel consistency and can feel wet when applied. For best application please follow the following application advice.
- A Prima sponge eyeshadow applicator
- Prima Mini Glitter Blending Buds
- Your fingertip
Firstly, you will need to be quite firm when picking up the pressed glitter. Scoop some glitter up and press against the side of the pan to remove any excess.
To ensure you get the thicker and fuller look, you will need to work in small sections, applying the glitter in a dabbing/smoothing motion and layer up the glitter until you achieve the desired effect.
Our pressed glitters can be applied over primer, eyeshadow or just added to the naked eyelid- there is no need to add any cosmetic fixing gel. All of our pressed glitters are high in pigmentation, long lasting and super sparkly. Find the application technique that suits you best and glitter like you mean it!
Find the application technique that suits you best and glitter like you mean it! You may also want to check out this blog.
We do always advise 48 hours before use do a patch test to see if your skin has any irritation. If you do feel irritation then rinse immediately. If any product does go in the eye, rinse the eye for effective removal. Always remove product thoroughly after use.
How to apply Prima 3D Lashes
MEASURE & TRIM YOUR PRIMA LASHES
Remove your Prima lashes gently from the tray by the lash band using either tweezers or your fingertips. Be careful to not pull too hard to ensure you do not lose any of the hairs and be sure to pick up your lashes by the band.
Measure lashes up to your eye so that it fits the length of your lash line. Trim precisely so that the lashes fall just short of the natural length of your eyes.
APPLY THE LASH GLUE
Hold the lashes using your fingertips or tweezers. Apply a thin layer of your chosen glue to the lash band. Let glue dry for about 30 seconds or until the glue becomes translucent and sticky.
APPLY TO YOUR LID
Take your lashes and carefully apply right above your natural lash line. Hold for a few seconds for the glue to dry and then release your hold. If required readjust the lashes or press down if needed on the ends. If you see the lash lifting, apply more adhesive to that area of the lash band and press down once again.
GET READY TO FLASH THOSE LASHES!
Ensure your lashes are fixed in place with no visible lifting. Once your glue is dry, you can choose to also apply mascara for a more dramatic look. You can also apply additional eyeliner or glitter of course! For an extra bit of sparkle, add our pressed glitters to the tips of your 3D lashes before or after application.